钢管混凝土脱空风险和脱空高度模拟及影响因素研究

Abstract: In order to accurately assess the harm of interface voids to the performance of concrete-filled steel tubes, quantify the void risk and clarify its key influencing factors, this paper adopts MIDAS FEA NX software to simulate and calculate the vo

浏览量:

关键词:

钢管混凝土;脱空;脱空风险系数;脱空高度;模拟

Key words:

Concrete-filled steel tube; Void; Void risk coefficient; Void height; Simulation

刊期:

2026年第5期

DOI:

10.19761/j.1000-4637.24110613

文章编号:

基金项目:

广西科技计划项目(桂科AB22036007)。

作者:

杨 睿1,徐 文2

单位:

1.江苏苏博特新材料股份有限公司,江苏 南京 211103;2.东南大学 材料科学与工程学院,江苏 南京 211189

摘要

摘   要:为准确评估钢管混凝土界面脱空对其性能的危害,量化脱空风险并厘清其关键影响因素,本文采用MIDAS FEA NX软件模拟计算了钢管混凝土的脱空风险系数和脱空高度,并研究了钢管尺寸和混凝土性能对脱空的影响。结果表明:在相同混凝土性能的情况下,钢管直径越小,厚度越大,脱空风险就越大,脱空发生时间也越早,钢管直径越大,脱空高度越大,但在钢管直径相同的情况下,钢管厚度对脱空高度的影响较小;在相同钢管尺寸的情况下,混凝土的自收缩越大,脱空风险越大,脱空发生时间越早;混凝土中掺入膨胀材料可有效降低脱空风险,膨胀峰值越大,峰值时间越晚,抵抗脱空的效果越好;混凝土的绝热温升对脱空的影响较小。研究结果可为钢管混凝土设计、施工质量控制及服役期安全预警提供参考。

Abstract: In order to accurately assess the harm of interface voids to the performance of concrete-filled steel tubes, quantify the void risk and clarify its key influencing factors, this paper adopts MIDAS FEA NX software to simulate and calculate the void risk coefficient and void height of concrete-filled steel tubes, and investigates the effects of steel tube dimensions and concrete properties on the occurrence of voids. The results show that under the same concrete properties, the smaller the steel tube diameter and the larger its thickness, the greater the void risk and the earlier the void initiation time. The larger the steel tube diameter, the higher the void height, while the steel tube thickness has a slight effect on the void height for concrete-filled steel tubes with the same diameter. Under the same steel tube dimensions, the greater the autogenous shrinkage of concrete, the higher the void risk and the earlier the void initiation time. Adding an expansive material to concrete can effectively reduce the void risk, and the larger the expansion peak value and the later its peak time, the better the anti-void performance. The adiabatic temperature rise of concrete exerts a minor influence on the generation of voids. The research results can provide a reference for the design, construction quality control and service period safety early warning of CFST structures.

结论

  (1)在本文设计的基准工况下,由于水化早期温度变形和自收缩变形同时发生,钢管与混凝土变形不一致,钢管-混凝土界面处的脱空风险较高,脱空后钢管仅发生温度变形且会恢复原状,脱空高度为混凝土在脱空后产生的总位移。
(2)在相同混凝土性能的情况下,钢管直径越小,厚度越大,脱空风险就越大,脱空发生时间也越早,钢管直径越大,脱空高度越大,但在钢管直径相同的情况下,钢管厚度对脱空高度的影响较小。
(3)在相同钢管尺寸的情况下,混凝土的自收缩越大,脱空风险越大,脱空发生时间越早。混凝土中掺入膨胀剂可有效降低脱空风险,在合理范围内,膨胀峰值越大,峰值时间越晚,抵抗脱空的效果越好。此外,混凝土的绝热温升对脱空的影响几乎可忽略。

参考文献

[1] 郑皆连.品质与风险:钢管混凝土拱桥[J].中国公路,2018,(22):40-42.
[2] 饶德军,张玉红,王忠建.钢管混凝土拱肋泵送混凝土脱空成因分析与试验观察[J].铁道建筑,2005(3):14-16.
[3] 沈书升.钢管混凝土拱桥拱肋脱空机理和相关结构稳定性影响研究[D].西安:长安大学,2014.
[4] 李定伦.钢管混凝土拱肋脱粘脱空受力机理研究[J].公路交通科技(应用技术版),2014,10(7):226-228.
[5] 顾春晓.钢管混凝土脱黏问题的调查与分析[J].西部交通科技,2017(7):65-68.
[6] 周水兴,李威.钢管混凝土拱桥常见病害成因分析[J].重庆交通大学学报(自然科学版),2013,32(增刊1):738-741,826.
[7] 童林,夏桂云,吴美君,等.钢管混凝土脱空的探讨[J].公路,2003(5):16-20.
[8] 吴德明,王福敏,殷祥林.基于温度影响的钢管混凝土脱空机理分析[J].重庆交通大学学报(自然科学版),2009,28(2):190-194.
[9] 谌越,王罡,郝萧斌,等.钢管混凝土脱粘机理及影响因素分析[J].钢结构(中英文),2022,37(7):20-30.
[10] 严仁章,刘佳奇,刘时龙,等.太阳辐射作用下钢管混凝土拱不均匀温度场及其引起的脱空分析与试验研究[J].中国公路学报,2021,34(1):79-92.
[11] 谭书林.多因素耦合作用下钢管混凝土拱桥脱空机理及影响研究[D].重庆:重庆交通大学,2019.
[12] 陈宝春,刘振宇.钢管混凝土拱桥温度问题研究综述[J].福州大学学报(自然科学版),2009,37(3):412-418.
[13] ROEDER C W,CAMERON B,BROWN C B.Composite action in concrete filled tubes[J].Journal of Structural Engineering,1999,125(5):477-484.
[14] 陈宝春,韦建刚,周俊,等.我国钢管混凝土拱桥应用现状与展望[J].土木工程学报,2017,50(6):50-61.

引用本文

杨睿,徐文.钢管混凝土脱空风险和脱空高度模拟及影响因素研究[J].混凝土与水泥制品,2026,53(5):113-119. YANG R,XU W,et al.Study on void risk, void height simulation and influencing factors of concrete-filled steel tubes[J].China Concrete and Cement Products,2026,53(5):113-119 (in Chinese).


上一个: 基于响应面法的混凝土防护涂料组成设计及性能研究

下一个: 基于离散元法的多因素条件下新拌混凝土堵塞规律研究

相关文件