基于响应面法的混凝土防护涂料组成设计及性能研究
Composition design and performance study of concrete protective coating based on response surface methodology
关键词:
混凝土防护涂料;响应面法;硅丙比;配合比优化;吸水率;黏结强度;色差值;耐碱性能
Key words:
Concrete protective coating; Response surface methodology; Silicone-acrylate ratio; Mix proportion optimization; Water absorption rate; Adhesion strength; Color difference value; Alkali resistance
刊期:
2026年第6期
DOI:
10.19761/j.1000-4637.25070322
文章编号:
基金项目:
作者:
谢 辉1,胡攀东1,王 川1,吴小梅2,陈 鸿2,高 旭2,*
单位:
1.武汉誉城千里建工有限公司,湖北 武汉 430051;2.武汉理工大学 土木工程与建筑学院,湖北 武汉 430070
摘要
摘 要:混凝土多孔且呈碱性,在服役环境中易受水分、紫外线、腐蚀介质等侵蚀而发生耐久性能退化,采用混凝土防护涂料进行表面防护,是延缓其劣化进程、延长服役寿命的有效手段。为探究混凝土防护涂料各组分的作用机制、解决传统经验法难以精准优化配合比的难题,本文以水性有机硅树脂乳液和丙烯酸乳液为基体制备了混凝土防护涂料,基于响应面法研究了硅丙比(3、4、5)、成膜助剂用量(1%、2%、3%)、消泡剂用量(0.4%、0.6%、0.8%)、滑石粉用量(2%、4%、6%)对涂层24 h吸水率、7 d黏结强度、紫外老化1 000 h色差值及耐碱性能的影响规律,并优化了混凝土防护涂料的配合比。结果表明:所建立的各项性能回归模型均具有较高的显著性与拟合精度,能够准确反映各因素与性能指标间的响应关系;硅丙比对防护涂料综合性能起主导作用,适当提高硅丙比可有效降低吸水率,提升黏结强度、耐候与耐碱性能;防护涂料的最优配合比为硅丙比4.54、成膜助剂用量1.98%、消泡剂用量0.63%、滑石粉用量5.43%,此时涂层的吸水率为1.91%、黏结强度为1.67 MPa、色差值为1.18、质量保持率为94.05%,各性能指标实测值与预测值的相对误差均小于5%,优化结果可靠。研究成果揭示了组分对防护涂料性能的作用机制,可为高性能混凝土防护涂料的配合比设计与工程应用提供理论支撑。
Abstract: Concrete is porous and alkaline, making it susceptible to durability degradation in service environments due to erosion from moisture, ultraviolet radiation, and corrosive media. The application of concrete protective coating for surface protection is an effective measure to slow down its deterioration and extend its service life. To investigate the mechanism of each component of concrete protective coatings and solve the problem that the traditional empirical method is difficult to accurately optimize the mix proportion, this paper prepared concrete protective coatings using waterborne silicone resin emulsion and acrylic emulsion as the matrix. Based on response surface methodology, the effects of silicone-acrylic ratio (3, 4, 5), film-forming additive content (1%, 2%, 3%), defoaming agent content (0.4%, 0.6%, 0.8%) and talc powder content (2%, 4%, 6%) on the 24 hours water absorption rate, 7-day adhesion strength, 1 000 hours UV-aging-induced color difference value and alkali resistance of the coatings were studied, and the mixing proportion of the concrete protective coating was optimized. The results show that the established regression models for various properties exhibit high significance and fitting accuracy, which can accurately reflect the response relationship between each factor and performance indicators. The silicone-acrylic ratio plays a dominant role in the comprehensive performance of the protective coating. Properly increasing the silicone-acrylic ratio can effectively reduce water absorption rate, and improve adhesion strength, weather resistance and alkali resistance. The optimal mix proportion of the protective coating is as follows: silicone-acrylate ratio of 4.54, film-forming additive content of 1.98%, defoaming agent content of 0.63%, and talc powder content of 5.43%. Under this mix proportion, the coating exhibits a water absorption rate of 1.91%, adhesion strength of 1.67 MPa, color difference value of 1.18, and mass retention rate of 94.05%. The relative errors between the measured and predicted values of all performance indicators are below 5%, confirming the reliability of the optimization results. The research findings reveal the mechanism of components on the performance of protective coatings, which can provide theoretical support for the mix proportion design and engineering application of high-performance concrete protective coatings.
结论
(1)针对吸水率、黏结强度、色差值、质量保持率四项性能,分别建立的二次多项式回归模型均具有较高的显著性与拟合精度,能准确反映各因素与性能指标间的响应关系。
(2)硅丙比对涂层性能的影响最显著,影响程度显著高于成膜助剂、消泡剂及滑石粉用量。适当提高硅丙比可有效形成致密疏水网络,降低涂层的吸水率与色差值,提高附着力和耐碱性能。
(3)经多目标优化得到的混凝土防护涂料最佳配合比为:硅丙比 4.54,成膜助剂用量 1.98%,消泡剂用量 0.63%,滑石粉用量 5.43%,此时涂层的吸水率为1.91%、黏结强度为1.67 MPa、色差值为1.18、质量保持率为94.05%,各性能指标的实测值与模型预测值的相对误差均小于 5%,优化所得配合比合理可靠。
(4)综合来看,该防护涂料通过合理调控硅丙比并匹配助剂与填料用量,可实现低吸水率、高黏结强度、低老化色差及优良耐碱性能的协同提升,为高性能防护涂料的配方设计与性能优化提供了试验支撑与技术参考。
参考文献
[1] Kim T K,Park J S.Experimental evaluation of the durability of concrete repair materials[J].Applied Sciences,2021,11(5):2303.
[2] Kang S P,Kim J H.Improvement of durability and change of pore structure for concrete surface by the penetrative surface protection agent[J].Journal of the Korea Concrete Institute,2006,18(1):125-132.
[3] Pan Xiaoying,Shi Zhenguo,Shi Caijun,et al.A review on concrete surface treatment: partⅠ: Types and mechanisms[J].Construction and Building Materials,2017,132:578-590.
[4] Almusallam A A,Khan F M,Dulaijan S U,et al.Effectiveness of surface coatings in improving concrete durability[J].Cement and Concrete Composites,2003,25(4/5):473-481.
[5] Zhang Zhizeng,Zhang Yunpeng,Ma Junqi,et al.The influence of fair-faced concrete protective agent on the resistance to freezing and thawing of concrete[J].Integrated Ferroelectrics,2021,215(1):166-178.
[6] Li Shaochun,Jiang Jialin,Geng Yongjuan,et al.Application of silane protective materials in the concrete durability improvement in recent years: a review[J].Engineering Failure Analysis,2024,160:108140.
[7] Hou Dongshuai,Wu Cong,Yin Bing,et al.Investigation of composite silane emulsion modified by in-situ functionalized graphene oxide for cement-based materials[J].Construction and Building Materials,2021,304:124662.
[8] 余茂林,邓安仲,沈海玉,等.改性纳米SiO2-苯丙乳液混凝土复合防护涂层的制备及性能研究[J].混凝土与水泥制品,2024(11):1-6.
[9] 熊红,王升福,熊贤银,等.磁铁矿重混凝土表观密度与强度影响因素试验研究[J].功能材料,2025,56(12):12217-12227.
[10] Mohd B M S,Mustapha F,Mazlan N,et al.Optimization of adhesion strength and microstructure properties by using response surface methodology in enhancing the rice husk ash-based geopolymer composite coating[J].Polymers,2020,12(11):2709.
[11] 龙庆.二氧化硅超细粉改性聚合物水泥防水涂料的制备及其对混凝土耐久性的影响[D].广州:华南理工大学,2016.
[12] 王轶.基于纳米改性硅丙清水混凝土保护剂的制备及性能研究[D].郑州:中原工学院,2020.
[13] 张云鹏.基于纳米改性的清水混凝土保护剂的配方及性能研究[D].郑州:中原工学院,2019.
[14] GB/T 1733—1993漆膜耐水性测定法[S].
[15] JT/T 695—2007混凝土桥梁结构表面涂层防腐技术条件[S].
[16] GB/T 1865—2009色漆和清漆 人工气候老化和人工辐射曝露 滤过的氙弧辐射[S].
[17] GB/T 9265—2009建筑涂料 涂层耐碱性的测定[S].
[18] Zhang Chaoyang,Zhang Shangfeng,Yu Jianwei,et al.Water absorption behavior of hydrophobized concrete using silane emulsion as admixture[J].Cement and Concrete Research,2022,154:106738.
[19] 李伟华,李舒婷,付波,等.硅酸盐防腐涂层多尺度改性研究进展[J].硅酸盐学报,2025,53(4):1018-1030.
[20] 黄雅婷,李连良,张翼,等.水性膨胀型钢结构防火涂料研究进展[J].中国塑料,2023,37(2):77-89.
[21] 刘竞,苗同梦,姜子清,等.混凝土表层防护涂料研究进展[J].化工进展,2021,40(10):5615-5623.
[22] Eilbeigi S,Tavakkolizadeh M,Masoodi R A.Innovative confinement of concrete using passive, active, and hybrid FRP-SMA systems: Experimental evaluation of mechanical performance[J].Case Studies in Construction Materials,2025,23:e05446.
[23] 刘彦钰,张博,罗伊明,等.滑石粉替代膨润土掺量对塑性混凝土性能的影响[J].水资源与水工程学报,2024,35(4):162-168.
[24] Derringer G,Suich R.Simultaneous optimization of several response variables[J].Journal of Quality Technology,1980,12(4):214-219.
引用本文
谢辉,胡攀东,王川,等.基于响应面法的混凝土防护涂料组成设计及性能研究[J].混凝土与水泥制品,2026,53(6):35-41. Xie Hui,Hu Pandong,Wang Chuan,et al.Composition design and performance study of concrete protective coating based on response surface methodology[J].China Concrete and Cement Products,2026,53(6):35-41 (in Chinese).
上一个: 基于长期监测结果的核电厂安全壳混凝土收缩和徐变模型分析
相关文件