涂覆工艺参数对异辛基三乙氧基硅烷乳液改性砂浆防护性能的影响

Influence of coating process parameters on protective performance of mortar modified with iso-octyl triethoxysilane emulsion

浏览量:

关键词:

砂浆;异辛基三乙氧基硅烷乳液;防护性能;接触角;渗透深度;吸水率

Key words:

Mortar; Iso-octyl triethoxysilane emulsion; Protective performance; Contact angle; Penetration depth; Water absorption rate

刊期:

2026年第8期

DOI:

10.19761/j.1000-4637.24100550

文章编号:

基金项目:

山东省自然科学基金项目(ZR2021ME215)。

作者:

张 宁1,王 岩2,马川义1,杨嘉城2,张圣涛1,管延华2,孙仁娟2,*

单位:

1.山东高速集团有限公司,山东 济南 250098;2.山东大学 齐鲁交通学院,山东 济南 250002

摘要

摘   要:针对水泥砂浆抗渗性差、易环境劣化的问题,异辛基三乙氧基硅烷(Iso-octyl triethoxysilane,IOTES)乳液可有效提升其表面防护性能,但目前相关研究多侧重材料配比,对涂覆量、涂覆次数及间隔时间等关键涂覆工艺参数的影响尚不明确。鉴于此,本文制备了IOTES乳液,通过分析砂浆表面接触角、IOTES乳液渗透深度和砂浆吸水率,研究了涂覆工艺参数(单次涂覆量、涂覆次数、涂覆间隔时间和防护后静置时间)对砂浆防护性能的影响。结果表明:增加单次涂覆量与涂覆次数均可提高涂覆总量,有效增强了IOTES乳液对试件的防护作用;当涂覆总量相同时,合理选择单次涂覆量和涂覆次数可有效提高IOTES乳液的渗透深度;随着涂覆间隔时间的增加,试件的表面接触角和IOTES乳液渗透深度降低,吸水率增加,吸水率降低比例降低;随防护后静置时间的延长,试件的防护性能先增强后趋于稳定。研究结果可为IOTES乳液在砂浆类水泥基构件中的高效防护施工提供借鉴。

Abstract: To address the poor resistance of cement mortar to water penetration and its susceptibility to environmental deterioration, iso-octyl triethoxysilane (IOTES) emulsion can be used to improve its surface protective performance. Nevertheless, existing relevant research mostly focuses on material mix proportions, while the effects of key coating process parameters including coating amount, number of coatings, and coating interval remain unclear. In view of this, an IOTES emulsion was prepared in this paper. By analyzing the surface contact angle of mortar, the penetration depth of IOTES emulsion into the mortar and the water absorption rate of mortar, the effects of coating process parameters (coating amount per application, number of coatings, coating interval time and post-treatment standing time) on the protective performance of mortar were investigated. The results show that increasing the coating amount per application and number of coatings can raise the total coating amount and significantly senhance the protective effect of IOTES emulsion on the specimens. At the same total coating amount, reasonably matching single-layer coating amount and number of coatings can effectively increase the penetration depth of IOTES emulsion. As the coating interval increases, the surface contact angle of the specimens and the penetration depth of the IOTES emulsion into the mortar decrease, the water absorption rate rises, and the percentage reduction in water absorption decreases. As the post-treatment standing time increases, the protective performance of the specimens increases at first and then tends to be stable. The findings can provide a reference for the efficient application of IOTES emulsion in the protective treatment of mortar-based cementitious components.

结论

(1)单次涂覆量与涂覆次数的增加提高了涂覆总量,与试件作用的硅烷量更多,增强了对试件的防护作用。随着单次涂覆量和涂覆次数的增加,IOTES乳液的渗透深度增加,但对试件表面接触角和试件吸水率的影响较小。当涂覆总量相同时,合适的单次涂覆量和涂覆次数可有效提高IOTES乳液的渗透深度。
(2)随着涂覆间隔时间的增加,试件的表面接触角和IOTES乳液渗透深度降低,吸水率增加,吸水率降低比例降低。建议相邻2次IOTES乳液的涂覆间隔时间不宜超过3 h,后续IOTES乳液的涂覆宜根据基体的表面状态确定,并在表面未完全干透前(表面有湿迹)进行涂覆。
(3)随防护后静置时间的延长,试件的防护性能先逐渐增强,后趋于稳定。为保证IOTES乳液的防护效果,涂覆完成后,宜保持基体干燥并静置3~7 d。

参考文献

[1] 陈华鹏,刘昌雨,江钰,等.钢筋混凝土结构锈蚀开裂模型研究[J].铁道学报,2023,45(10):180-188.
[2] 王岩,马川义,秦宇,等.正硅酸乙酯基防护剂对水泥砂浆吸水率的影响[J].混凝土与水泥制品,2025(4):5-9.
[3] 孙传武,王学志,辛明,等.玄武岩-纤维素混杂纤维混凝土抗冻性能研究[J].混凝土与水泥制品,2024(7):65-69.
[4] 宋辰,姜超,顾祥林.碳化对混凝土微孔特征和吸水性能的影响[J].同济大学学报(自然科学版),2024,52(4):567-573.
[5] 张磊,高瑞晓,荣辉,等.渗透型有机硅涂覆方式对砂浆防护性能的影响及机制研究[J].建筑材料学报,2019,22(4):523-529,537.
[6] 王海良,李懿祯,荣辉,等.有机硅防护剂对铝酸盐水泥砂浆防护性能的影响[J].建筑材料学报,2019,22(4):516-522.
[7] 卢云杉,王桥,周伟,等.水工混凝土新型防护修复材料研究进展[J].混凝土,2023(3):177-188.
[8] Li Shaochun,Jiang Jialin,Geng Yongjuan,et al.Application of silane protective materials in the concrete durability improvement in recent years: A review[J].Engineering Failure Analysis,2024,160:108140.
[9] Zheng Meng,Zhang Lu,Feng Yakai.A review on silane and siloxane materials: Enhancing durability of cementitious materials through surface treatments[J].Journal of Materials Science,2024,59(23):10119-10139.
[10] T/CCES 12—2020混凝土结构用有机硅渗透型防护剂应用技术规程[S].
[11] 裴须强,朱玉雪.硅烷防水材料的研制及其在混凝土防护中的应用工艺探究[J].新型建筑材料,2022,49(7):67-71.
[12] 马原.水性硅烷混凝土防腐乳液的制备及性能研究[J].中国胶粘剂,2020,29(1):32-36.
[13] 曹文凯,张康捷,李果,等.纳米材料在混凝土耐久性防护涂层中的应用[J].华北水利水电大学学报(自然科学版),2023,44(4):60-68.
[14] 李萌萌,吴聪,金祖权,等.滨海环境下水泥基材料有机硅防护涂层的研究进展[J].建筑材料学报,2024,27(4):332-342.
[15] 张馨元.混凝土用硅烷类防护材料的制备及其对混凝土耐久性影响[D].青岛:青岛理工大学,2014.
[16] 张翠,李绍纯,赵铁军,等.硅烷乳液、TEOS和硅溶胶对水泥砂浆防水性能的影响[J].混凝土,2016(7):130-132,137.
[17] 陈旭.TEOS/异丁基三乙氧基硅烷复合乳液的制备及其对水泥基材料耐久性能的影响[D].青岛:青岛理工大学,2016.
[18] 高岩.硅烷复合凝胶的制备及其对水泥基材料耐久性能的影响研究[D].青岛:青岛理工大学,2017.
[19] 张友来,李绍纯,侯东帅,等.氧化石墨烯/硅烷复合乳液对混凝土防渗透性能的影响[J].涂料工业,2018,48(7):13-18,52.
[20] 武子晗,李绍纯,眭世玉,等.含银复合乳液对混凝土表面抗菌性能的影响[J].硅酸盐通报,2022,41(6):2007-2014.
[21] Zhang Peng,Wang Wenshuai,Lv Yajun,et al.Effect of polymer coatings on the permeability and chloride ion penetration  resistances of nano-particles and fibers-modified cementitious composites[J].Polymers,2022,14(16):3258.
[22] Basheer L,Cleland D J.Durability and water absorption properties of surface treated concretes[J].Materials and Structures,2011,44(5):957-967.

引用本文

张宁,王岩,马川义,等.涂覆工艺参数对异辛基三乙氧基硅烷乳液改性砂浆防护性能的影响[J].混凝土与水泥制品,2026,53(8):20-24. Zhang Ning,Wang Yan,Ma Chuanyi,et al.Influence of coating process parameters on protective performance of mortar modified with iso-octyl triethoxysilane emulsion[J].China Concrete and Cement Products,2026,53(8):20-24 (in Chinese).


上一个: 超低温环境下SAP对水泥净浆孔隙结构和热学性能的影响研究

下一个: 不同载体微生物自修复混凝土的裂缝修复规律及矿化机制

相关文件