苏州混凝土水泥制品研究院有限公司

头部文案

发布时间:2020-01-06 00:00:00
全国建材科技期刊
全国中文核心期刊
中国科技论文统计源期刊
万方数据-数字化期刊群入网期刊
中国学术期刊(光盘版)全文收录期刊
华东地区优秀科技期刊
江苏省期刊方阵“双效期刊”
中国期刊网全文收录期刊
中国科技期刊数据库全文收录期刊
设直肋薄壁方形钢管混凝土短柱性能研究
Properties Research on Square Thin-walled Steel Tube Concrete Short Column Inside A One-way Straight Ribs
2014年第12期
方形薄壁钢管混凝土;短柱;含钢率;加劲肋
Square thin-walled steel tube concrete; Short column; Steel content; Stiffening rib
2014年第12期
1000-4637(2014)12-43-04
宿迁市科技局项目(Z201207);宿迁学院重点科研项目(2013KY21)
左 工1,王振波2,乔 燕1,李泽良1
1.宿迁学院建筑工程系,223800;2.南京工业大学土木工程学院,211816

左 工1,王振波2,乔 燕1,李泽良1

浏览量:
1000
摘 要:为了分析薄壁方形钢管混凝土的力学性能,考虑到钢材成本,在含钢量不变的条件下,对 8个短柱试件进行轴压试验。通过改变构件的截面厚度和加肋形式,分析了薄壁方管内侧设单向直肋、设双向直肋和外部设单向直肋对薄壁钢管混凝土短柱的极限承载力、破坏特征及受力性能的影响。试验结果表明,在含钢量不变的情况下,构件内部设肋可以有效延缓薄壁方形钢管混凝土构件管壁局部屈曲的发生,设双肋比设单肋效果更加明显,但在改善构件极限承载力方面,效果并不明显;外侧设加劲肋的设置不能有效延缓钢管混凝土管壁的局部屈曲。 Abstract: In order to analyze the mechanical properties of thin-walled square steel tube concrete, and consider from the angle of the economic cost of steel, under the condition of invariable in the steel ratio, the axial compression tests of eight short column specimens are carried out. By changing the component of cross section thickness and ribbed forms, the influence of thin-walled square tube inside a one-way straight rib, a two-way straight rib and outside a one-way straight ribs on the ultimate bearing capacity, failure characteristics and mechanical properties of the thin-walled concrete filled steel tubular short column are analyzed. The test results show that under the condition of the same steel content, setting up ribs inside memberscan effectively slow down the wall local buckling of the square concrete filled steel tubular members, and effect of setting up double ribs is more obvious than that of a single rib, but in improving component limit bearing capacity, the effect is not very obvious; setting up the stiffening rib outside memberscannot effectively delay the local buckling of steel tube concrete wall.
英文名 : Properties Research on Square Thin-walled Steel Tube Concrete Short Column Inside A One-way Straight Ribs
刊期 : 2014年第12期
关键词 : 方形薄壁钢管混凝土;短柱;含钢率;加劲肋
Key words : Square thin-walled steel tube concrete; Short column; Steel content; Stiffening rib
刊期 : 2014年第12期
DOI :
文章编号 : 1000-4637(2014)12-43-04
基金项目 : 宿迁市科技局项目(Z201207);宿迁学院重点科研项目(2013KY21)
作者 : 左 工1,王振波2,乔 燕1,李泽良1
单位 : 1.宿迁学院建筑工程系,223800;2.南京工业大学土木工程学院,211816

左 工1,王振波2,乔 燕1,李泽良1

摘要
参数
结论
参考文献
引用本文

摘   要:为了分析薄壁方形钢管混凝土的力学性能,考虑到钢材成本,在含钢量不变的条件下,对 8个短柱试件进行轴压试验。通过改变构件的截面厚度和加肋形式,分析了薄壁方管内侧设单向直肋、设双向直肋和外部设单向直肋对薄壁钢管混凝土短柱的极限承载力、破坏特征及受力性能的影响。试验结果表明,在含钢量不变的情况下,构件内部设肋可以有效延缓薄壁方形钢管混凝土构件管壁局部屈曲的发生,设双肋比设单肋效果更加明显,但在改善构件极限承载力方面,效果并不明显;外侧设加劲肋的设置不能有效延缓钢管混凝土管壁的局部屈曲。

Abstract: In order to analyze the mechanical properties of thin-walled square steel tube concrete, and consider from the angle of the economic cost of steel, under the condition of invariable in the steel ratio, the axial compression tests of eight short column specimens are carried out. By changing the component of cross section thickness and ribbed forms, the influence of thin-walled square tube inside a one-way straight rib, a two-way straight rib and outside a one-way straight ribs on the ultimate bearing capacity, failure characteristics and mechanical properties of the thin-walled concrete filled steel tubular short column are analyzed. The test results show that under the condition of the same steel content, setting up ribs inside memberscan effectively slow down the wall local buckling of the square concrete filled steel tubular members, and effect of setting up double ribs is more obvious than that of a single rib, but in improving component limit bearing capacity, the effect is not very obvious; setting up the stiffening rib outside memberscannot effectively delay the local buckling of steel tube concrete wall.

关键词:
方形薄壁钢管混凝土;短柱;含钢率;加劲肋
扫二维码用手机看
未找到相应参数组,请于后台属性模板中添加
(1)在总含钢量不变前提下,设置加劲肋的薄壁钢管混凝土柱的套箍作用降低,其极限承载力低于无肋钢管混凝土柱;相同宽厚比条件下,内部设单肋比无肋对提高构件的承载力的能力略低。
(2)在含钢率不变的前提下,构件内部设肋可以有效的延缓壁方形钢管混凝土构件管壁局部屈曲的发生,设双肋比设单肋效果更加明显。但在改善构件极限承载力方面,效果并不十分明显。
(3)在含钢率不变的前提下,加劲肋设在管壁内侧比设置在外侧对于延缓壁方形钢管混凝土构件管壁局部屈曲效果明显,对于设置在外侧的单肋构件,其构件屈曲效果与无肋构件较为相似。
(4)计算结果与试验现象吻合良好,为进一步探讨薄壁方形钢管混凝土短柱的力学性能、钢板强度、加肋形式、钢板宽厚比、加肋数量的研究提供了有力的依据。
[1] 陶忠,于清.新型组合结构柱—试验、理论和方法[M].北京:科学出版社,2006.
[2] 韩林海.钢管混凝土结构—理论和实践[M].北京:科学出版社,2004.
[3] 张耀春,陈勇.设直肋方形薄壁钢管混凝土短柱的试验研究与有限元分析[J].建筑结构学报,2006.27(5):16-22.
[4] 刘永健,张俊光,徐开磊,等.设纵肋钢箱混凝土轴压短柱试验研究[J].建筑结构学报,2011(10):159-165.
[5] O'Shea M D, Bridge R Q. Design of circular thin-walled concrete filled steel[J].Journal of Structural Engineering,2000,126(11):1295-1303.
[6] 陶忠,王志滨,韩林海.采用加劲肋改善薄壁方钢管混凝土工作性能初探[C].第十三届全国结构工程学术会议文集(第Ⅱ册),2004:112-115.
[7] 李佰寿,张平,金爱花,等.薄壁方形钢管再生块体混合短柱轴压试验研究[J].土木工程学报,2012(10):125-134.
[8] 许成祥,朱长安,许淑珍,等.设置钢筋加劲肋薄壁方钢管混凝土短柱试验研究[J].建筑结构学报,2009(S2):231-236.
   

相关文件

暂时没有内容信息显示
请先在网站后台添加数据记录。

关注《混凝土与水泥制品》

总访问量 468,401   网站统计

官方微信公众号关闭
苏州混凝土水泥制品研究院有限公司

关于我们    |    联系我们    |    订购杂志    |    回到顶部

版权所有:中国混凝土与水泥制品网  苏ICP备10086386号   网站建设:中企动力 苏州

版权所有:中国混凝土与水泥制品网

苏ICP备10086386号

网站建设:中企动力 苏州