苏州混凝土水泥制品研究院有限公司

头部文案

发布时间:2020-01-06 00:00:00
全国建材科技期刊
全国中文核心期刊
中国科技论文统计源期刊
万方数据-数字化期刊群入网期刊
中国学术期刊(光盘版)全文收录期刊
华东地区优秀科技期刊
江苏省期刊方阵“双效期刊”
中国期刊网全文收录期刊
中国科技期刊数据库全文收录期刊
不同轴压比下碳纤维混凝土柱滞回性能研究
Study on Hysteretic Behavior of Carbon Fiber Reinforced Concrete Column under Different Axial Compression Ratio
2014年第12期
碳纤维混凝土柱;轴压比;滞回性能;有限元分析
Carbon fiber reinforced concrete column; Axial compression ratio; Hysteretic behavior; Finite element analysis
2014年第12期
1000-4637(2014)12-60-05
国家留学基金项目(201308210105)
徐亚丰,陈 谦,张晓平
沈阳建筑大学土木工程学院,110168

徐亚丰,陈 谦,张晓平

浏览量:
1000
摘 要:采用C30混凝土按碳纤维体积掺量2‰进行配合比设计,制作了3个试验试件柱,对其进行水平低周往复加载,分析其在轴压比0.4、0.5、0.6下试件的滞回曲线、骨架曲线及位移延性系数;同时采用ABAQUS软件对碳纤维混凝土柱的滞回性能进行有限元分析,得到碳纤维柱的滞回曲线和应力云图。结果表明,轴压比的变化对试件滞回曲线的饱满程度影响不大,不同轴压比下试件的滞回曲线均比较饱满,没有出现捏拢现象,到达极限承载力后,曲线下降平缓;随着轴压比的增大,试件的极限承载力降低,所对应的极限位移和延性系数均减小。采用ABAQUS软件模拟得到的曲线与试验所得曲线吻合较好。 Abstract: Three specimens of carbon fiber reinforced concrete columns with C30 concrete strength grade and 2‰ carbon fiber are tested to study their hysteresis curve, skeleton curve and displacement ductility coefficient when the axial compressive ratios are 0.4, 0.5 and 0.6. And carbon fiber concrete columns are analyzed by using the finite element software ABAQUS, the hysteretic curve and stress nephogram of the columns are achieved. The results show that the change of axial compression ratio has little influence on the full extent of the hysteretic curves. The hysteretic curves under different axial compression ratios are full without significant pinch phenomenon. When the limit bearing capacity of the columns is reached, the skeleton curve decreases slowly. With the increase of axial load ratio, the ultimate bearing capacity and limit displacement decrease. The simulation curve and experimental curve are in good agreement which proved the rationality of simulation.
英文名 : Study on Hysteretic Behavior of Carbon Fiber Reinforced Concrete Column under Different Axial Compression Ratio
刊期 : 2014年第12期
关键词 : 碳纤维混凝土柱;轴压比;滞回性能;有限元分析
Key words : Carbon fiber reinforced concrete column; Axial compression ratio; Hysteretic behavior; Finite element analysis
刊期 : 2014年第12期
DOI :
文章编号 : 1000-4637(2014)12-60-05
基金项目 : 国家留学基金项目(201308210105)
作者 : 徐亚丰,陈 谦,张晓平
单位 : 沈阳建筑大学土木工程学院,110168

徐亚丰,陈 谦,张晓平

摘要
参数
结论
参考文献
引用本文

摘   要:采用C30混凝土按碳纤维体积掺量2‰进行配合比设计,制作了3个试验试件柱,对其进行水平低周往复加载,分析其在轴压比0.4、0.5、0.6下试件的滞回曲线、骨架曲线及位移延性系数;同时采用ABAQUS软件对碳纤维混凝土柱的滞回性能进行有限元分析,得到碳纤维柱的滞回曲线和应力云图。结果表明,轴压比的变化对试件滞回曲线的饱满程度影响不大,不同轴压比下试件的滞回曲线均比较饱满,没有出现捏拢现象,到达极限承载力后,曲线下降平缓;随着轴压比的增大,试件的极限承载力降低,所对应的极限位移和延性系数均减小。采用ABAQUS软件模拟得到的曲线与试验所得曲线吻合较好。

Abstract: Three specimens of carbon fiber reinforced concrete columns with C30 concrete strength grade and 2‰ carbon fiber are tested to study their hysteresis curve, skeleton curve and displacement ductility coefficient when the axial compressive ratios are 0.4, 0.5 and 0.6. And carbon fiber concrete columns are analyzed by using the finite element software ABAQUS, the hysteretic curve and stress nephogram of the columns are achieved. The results show that the change of axial compression ratio has little influence on the full extent of the hysteretic curves. The hysteretic curves under different axial compression ratios are full without significant pinch phenomenon. When the limit bearing capacity of the columns is reached, the skeleton curve decreases slowly. With the increase of axial load ratio, the ultimate bearing capacity and limit displacement decrease. The simulation curve and experimental curve are in good agreement which proved the rationality of simulation. 

关键词:
碳纤维混凝土柱;轴压比;滞回性能;有限元分析
扫二维码用手机看
未找到相应参数组,请于后台属性模板中添加

(1)无论轴压比如何变化,碳纤维混凝土柱的滞回曲线均比较饱满,表明碳纤维混凝土具有良好的耗能性能。 

(2)随着轴压比的增加,试件的极限承载力降低,所对应的极限位移减小,表明较低的轴压比不仅可以充分发挥材料的性能,而且延缓了节点峰值荷载的到来。

(3)随着轴压比的增大,试件的位移延性系数减小,表明轴压比的增大使试件的塑形变形能力减弱,但影响不是很大。
[1] 任彦华,程赫明,何天淳,等.碳纤维混凝土的力学性能研究[J].云南农业大学学报,2010,25(5):697-702.
[2] 张卫东,徐学燕.碳纤维混凝土的特性及发展前景[J].森林工程,2004,20(1):61-63.
[3] 邓燕,高文强.碳纤维混凝土增强机理概述[J].珠江现代建设,2009(1):34-35.
[4] 蔡传国,韦忠瑄,杨绪普.纤维增强混凝土对剪压柱塑性铰形成影响的比较试验[J].混凝土与水泥制品,2012(6):41-45.
[5] 梁福康.碳纤维混凝土[J].建筑技术,2000,32(1):17.
[6] 周尚志,党发宁.单轴压缩CT条件下混凝土细观结构破裂分析[J].海洋工程,2009(5):89-94.
[7] 刘齐茂,燕柳斌.基于零阶和一阶优化算法的建筑结构抗震优化设计[J].华南地震,2008,28(4):27-33.
[8] 孙鹏举,徐亚丰.钢骨-钢管混凝土框架节点滞回性能研究有限元分析[C].第八届沈阳科学学术年会论文集.北京:中国学术期刊杂志,2011.
[9] 于良,程华,靳雨欣,等.碳纤维混凝土单轴受压应力-应变本构关系[J].后勤工程学院学报,2013,29(4):6-12.
[10] 徐亚丰,王越.碳纤维钢骨-钢管混凝土柱抗震性能试验研究与有限元分析[J].沈阳建筑大学学报:自然科学版,2013(4):612-620.
[11] 李威.圆钢管混凝土柱-钢梁外环板式框架节点抗震性能研究[D]. 北京:清华大学,2011. 
 

相关文件

暂时没有内容信息显示
请先在网站后台添加数据记录。

关注《混凝土与水泥制品》

总访问量 468,401   网站统计

官方微信公众号关闭
苏州混凝土水泥制品研究院有限公司

关于我们    |    联系我们    |    订购杂志    |    回到顶部

版权所有:中国混凝土与水泥制品网  苏ICP备10086386号   网站建设:中企动力 苏州

版权所有:中国混凝土与水泥制品网

苏ICP备10086386号

网站建设:中企动力 苏州