磷石膏基复合材料的制备及性能研究_《混凝土与水泥制品》杂志社

头部文案

发布时间：2020-01-06 00:00:00

全国建材科技期刊
全国中文核心期刊
中国科技论文统计源期刊
万方数据-数字化期刊群入网期刊
中国学术期刊（光盘版）全文收录期刊

华东地区优秀科技期刊
江苏省期刊方阵“双效期刊”
中国期刊网全文收录期刊
中国科技期刊数据库全文收录期刊



磷石膏基复合材料的制备及性能研究

Study on the Preparation and Performance of Phosphogypsum-based Composites

2021年第12期

磷石膏；复合材料；抗压强度；抗折强度；数值分析；吸水率；软化系数

Phosphogypsum; Composite material; Compressive strength; Flexural strength; Numerical analysis; Water absorption; Softening coefficient

2021年第12期

10.19761/j.1000-4637.2021.12.094.06

贵州省科技计划项目（黔科合基础2018[1405]）。

柏洁1，周华2，谢嘉骥3，文伟1，丁俊豪1，冯选辉1

1.贵州大学土木工程学院，贵州贵阳 550025；2.贵州电力建设监理咨询有限责任公司，贵州贵阳 550002；3.天津航道局，天津 300450

柏洁1，周华2，谢嘉骥3，文伟1，丁俊豪1，冯选辉1

柏洁,周华,谢嘉骥,等.磷石膏基复合材料的制备及性能研究[J].混凝土与水泥制品,2021(12):94-99.

BAI J,ZHOU H,XIE J J,et al.Study on the Preparation and Performance of Phosphogypsum-based Composites[J].China Concrete and Cement Products,2021(12):94-99.

浏览量:

1000

摘要：以磷石膏、粉煤灰、矿渣微粉、生石灰为主要原料制备了磷石膏基复合材料，研究了磷石膏基复合材料性能的影响因素，并通过多变量数值分析得到了最优配合比。结果表明：当磷石膏、粉煤灰、矿渣微粉、生石灰的质量比为1∶0.4∶0.06∶0.03时，制备的磷石膏基复合材料的抗压、抗折强度均较高；掺入6‰防水剂对磷石膏基复合材料的抗压强度提升较大，复掺3‰减水剂+3‰防水剂对抗折强度提升较大；当水胶比为0.38~0.40时，磷石膏基复合材料的强度较高；21 ℃蒸汽养护14 d可使磷石膏基复合材料的强度达到最佳，但蒸汽养护会导致磷石膏基复合材料的吸水率增大、软化系数降低；通过数值分析建立的多变量磷石膏基复合材料的强度计算公式，可以得出单一变量下磷石膏基复合材料的强度值和多变量下磷石膏基复合材料的强度值与对应原材料掺量之间的关系。 Abstract: The phosphogypsum-based composites were prepared with phosphogypsum, fly ash, slag powder and quicklime as main raw materials. The factors affecting the performance of phosphogypsum-based composites were studied, and the optimal mix proportion was obtained through multivariate numerical analysis. The results show that when the mass ratio of phosphogypsum, fly ash, slag powder, and quicklime is 1∶0.4∶0.06∶0.03, the compressive and flexural strengths of the prepared phosphogypsum-based composite materials are higher. The compressive strength of phosphogypsum-based composites is greatly improved by adding 6‰ water-repellent agent, and the flexural strength of phosphogypsum-based composites is greatly improved by adding 3‰ water-reducing agent + 3‰ water-repellent agent. When the water-binder ratio is 0.38~0.40, the strength of phosphogypsum-based composites is higher. Steam curing at 21 ℃ for 14 days can optimize the strength of phosphogypsum-based composites, but steam curing will increase the water absorption and decrease the softening coefficient of phosphogypsum-based composites. Through the strength calculation formula of multivariable phosphogypsum-based composites established by numerical analysis, the relationship between the strength value of phosphogypsum-based composites under single variable and the strength value of phosphogypsum-based composites under multivariable and the corresponding raw material content can be obtained.

英文名 : Study on the Preparation and Performance of Phosphogypsum-based Composites

刊期 : 2021年第12期

关键词 : 磷石膏；复合材料；抗压强度；抗折强度；数值分析；吸水率；软化系数

Key words : Phosphogypsum; Composite material; Compressive strength; Flexural strength; Numerical analysis; Water absorption; Softening coefficient

刊期 : 2021年第12期

DOI : 10.19761/j.1000-4637.2021.12.094.06

文章编号 :

基金项目 : 贵州省科技计划项目（黔科合基础2018[1405]）。

作者 : 柏洁1，周华2，谢嘉骥3，文伟1，丁俊豪1，冯选辉1

单位 : 1.贵州大学土木工程学院，贵州贵阳 550025；2.贵州电力建设监理咨询有限责任公司，贵州贵阳 550002；3.天津航道局，天津 300450

柏洁1，周华2，谢嘉骥3，文伟1，丁俊豪1，冯选辉1

柏洁,周华,谢嘉骥,等.磷石膏基复合材料的制备及性能研究[J].混凝土与水泥制品,2021(12):94-99.

BAI J,ZHOU H,XIE J J,et al.Study on the Preparation and Performance of Phosphogypsum-based Composites[J].China Concrete and Cement Products,2021(12):94-99.





摘要

参数

结论

参考文献

引用本文

Abstract: The phosphogypsum-based composites were prepared with phosphogypsum, fly ash, slag powder and quicklime as main raw materials. The factors affecting the performance of phosphogypsum-based composites were studied, and the optimal mix proportion was obtained through multivariate numerical analysis. The results show that when the mass ratio of phosphogypsum, fly ash, slag powder, and quicklime is 1∶0.4∶0.06∶0.03, the compressive and flexural strengths of the prepared phosphogypsum-based composite materials are higher. The compressive strength of phosphogypsum-based composites is greatly improved by adding 6‰ water-repellent agent, and the flexural strength of phosphogypsum-based composites is greatly improved by adding 3‰ water-reducing agent + 3‰ water-repellent agent. When the water-binder ratio is 0.38~0.40, the strength of phosphogypsum-based composites is higher. Steam curing at 21 ℃ for 14 days can optimize the strength of phosphogypsum-based composites, but steam curing will increase the water absorption and decrease the softening coefficient of phosphogypsum-based composites. Through the strength calculation formula of multivariable phosphogypsum-based composites established by numerical analysis, the relationship between the strength value of phosphogypsum-based composites under single variable and the strength value of phosphogypsum-based composites under multivariable and the corresponding raw material content can be obtained.

扫二维码用手机看

[1] KURAHASHI T,SHIOMI H,KITAGUTI S,et al.Effect of Addition to the Gypsum on Phosphorous Removal Properties of Wollastonite-type Adsorbent[J].Journal of the Society of Materials Science,2007,56(6):516-520.
[2] 韩青,罗康碧,李沪萍,等．磷石膏的开发利用现状[J]．化工科技,2012,20(1):53-58.
[3] 兰文涛,吴爱祥,王贻明,等.半水磷石膏充填强度影响因素试验[J].哈尔滨工业大学报,2019,51(8):128-135.
[4] 李夕兵,刘冰,姚金蕊,等.全磷废料绿色充填理论与实践[J].中国有色金属报,2018,28(9):1845-1865.
[5] 吴赤球,吕伟.磷石膏在水泥制品中的应用[J].混凝土与水泥制品,2019(1):52-53.
[6] 吴赤球,吕伟,孙涛.一种磷石膏轻骨料制备技术[J].混凝土与水泥制品,2020(2):98-100.
[7] 尹明干,汪晖,石飞停.改性磷石膏的强度与孔结构的研究[J].材料导报,2018,32(S2):526-529.
[8] 王新民,薛希龙,张钦礼,等.碎石和磷石膏联合胶结充填最佳配比及应用[J].中南大学学报(自然科学版),2015,46(10):3767-3773.
[9] 戴绍斌,翁婉琳,黄俊,等.现浇磷石膏填充墙RC框架结构周期折减系数研究[J].建筑结构,2019,49(15):94-97,70.
[10] 黄照东,张德明,刘一锴,等.柠檬酸浸法预处理对磷石膏充填体性能的影响[J].黄金科学技术,2020,28(1):97-104.
[11] 贾兴文,吴洲,马英.磷石膏建材资源化利用现状[J].材料导报,2013(23):143-145,150.
[12] 刘代俊,刘玉琨,杨广谱,等.磷资源加工研究进展:6.利用磷石膏生产高强度砌块及储能砌块[J].磷肥与复肥,2009,24(5):8-10.
[13] 张立力,华苏东,诸华军,等.高镁镍渣-磷石膏基胶凝材料固化和改良盐渍土的性能[J].材料导报,2020,34(9):9034-9040.
[14] 马克俭,高国富,张华刚,等.空间网格式框架结构在多、高层大开间灵活划分房间石膏节能建筑中的研究与应用综述[J].空间结构,2009,15(3):66-84,65.
[15] 马克俭,卢亚琴,张华刚,等.以磷石膏为模壳的新型钢筋混凝土结构体系试验研究[J].建筑结构学报,2009,30(6):128-133.
[16] 梁凡凡,张华刚,罗玚,等.现浇磷石膏弹性模量和泊松比的初步试验研究[J].贵州大学学报(自然科学版),2013,30(2):81-85.
[17] 谢浪,周银笙,罗双,等.玄武岩纤维改性脱硫建筑石膏研究[J].非金属矿,2020,43(6):49-51,55.
[18] 易秋,陈红鸟,曾洲,等.聚丙烯纤维增强磷石膏复合材料力学性能研究[J].贵州大学学报(自然科学版),2018,35(1):99-103.
[19] 曾洲,陈红鸟,易秋,等.聚乙烯纤维增强磷石膏试件力学性能试验研究[J].贵州大学学报(自然科学版),2017,34(6):85-89.
[20] 王青原,孙敬明,陈红鸟,等.玻璃纤维增强磷石膏复合材料力学性能研究[J].贵州大学学报(自然科学版),2017,34(4):99-103.
[21] 吴超.磷石膏基干混砂浆的研制及外加剂影响机理[D]. 贵州:贵州大学,2020.

上一个

无

下一个

再生粗骨料品质和掺量对再生混凝土力学性能的影响

头部文案

磷石膏基复合材料的制备及性能研究

相关文件