苏州混凝土水泥制品研究院有限公司

头部文案

发布时间:2020-01-06 00:00:00
全国建材科技期刊
全国中文核心期刊
中国科技论文统计源期刊
万方数据-数字化期刊群入网期刊
中国学术期刊(光盘版)全文收录期刊
华东地区优秀科技期刊
江苏省期刊方阵“双效期刊”
中国期刊网全文收录期刊
中国科技期刊数据库全文收录期刊
高温热处理对泡沫混凝土性能的影响
Effects of High Temperature Heat Treatment on Performance of Foam Concrete
2017年第3期
泡沫混凝土;轻质;高温
Foam concrete; Lightweight; High temperature
2017年第3期
1000-4637(2017)03-55-05
国家重点研发计划项目(2016YFC0701004)
张 雷1,李 军1,2,卢忠远2,张玉苹1
1.西南科技大学 材料科学与工程学院,绵阳 621010;2.西南科技大学 四川省非金属复合与功能 材料重点实验室-省部共建国家重点实验室培育基地, 绵阳 621010;

张 雷1,李 军1,2,卢忠远2,张玉苹1

张雷,李军,卢忠远,等.高温热处理对泡沫混凝土性能的影响[J].混凝土与水泥制品,2017(3):55-59.

ZHANG L, LI J, LU Z Y,et al.Effects of High Temperature Heat Treatment on Performance of Foam Concrete[J].China Concrete and Cement Products,2017(3):55-59.

浏览量:
1000
摘  要:采用物理发泡方式制备了不同密度等级泡沫混凝土,研究了泡沫混凝土经高温热处理后的性能和结构演化。结果表明:随热处理温度提高,各密度泡沫混凝土的质量损失增加、抗压强度降低、吸水率增加,且均在800℃时趋于一致。密度等级对高温热处理后的泡沫混凝土性能影响较为明显。在400℃以前,300~400kg/m3密度等级的泡沫混凝土质量和抗压强度损失更大,吸水率增加更多;在600℃温度处理后,各密度等级的泡沫混凝土基本性能均出现明显下降;在800℃时,各密度等级泡沫混凝土基本性能趋于一致,质量损失为20%左右,质量吸水率为65%~70%,基本丧失抗压强度。Abstract:Foamconcretewithdifferentdensitywasprepared,thepropertiesandstructuralevolutionoffoamconcreteafterhightemperatureheattreatmentwerestudied.Theresultsshowedthatthemasslossincreases,thecompressivestrengthdecreases,thewaterabsorptionincreaseswiththeincreasingofheattreatmenttemperatureandallthesetendtobeconsistentat800℃.Theeffectofdifferentdensityontheperformanceoffoamconcreteafterhightemperatureheattreatmentisobvious.Themasslossandwaterabsorptionincreasehigher,thecompressivestrengthdecreasehigherwhenthedensityoffoamconcreteis300~400kg/m3under400℃.Thebasicperformanceofdifferentdensityoffoamconcretedecreaseobviouslywhentheheattreatmenttemperatureis600℃.Allthesebasicperformancetendtobeconsistentat800℃,themassloseis20%,waterabsorptionis65%~70%andthecompressivestrengthisalmostzero.
英文名 : Effects of High Temperature Heat Treatment on Performance of Foam Concrete
刊期 : 2017年第3期
关键词 : 泡沫混凝土;轻质;高温
Key words : Foam concrete; Lightweight; High temperature
刊期 : 2017年第3期
DOI :
文章编号 : 1000-4637(2017)03-55-05
基金项目 : 国家重点研发计划项目(2016YFC0701004)
作者 : 张 雷1,李 军1,2,卢忠远2,张玉苹1
单位 : 1.西南科技大学 材料科学与工程学院,绵阳 621010;2.西南科技大学 四川省非金属复合与功能 材料重点实验室-省部共建国家重点实验室培育基地, 绵阳 621010;

张 雷1,李 军1,2,卢忠远2,张玉苹1

张雷,李军,卢忠远,等.高温热处理对泡沫混凝土性能的影响[J].混凝土与水泥制品,2017(3):55-59.

ZHANG L, LI J, LU Z Y,et al.Effects of High Temperature Heat Treatment on Performance of Foam Concrete[J].China Concrete and Cement Products,2017(3):55-59.

摘要
参数
结论
参考文献
引用本文

摘   要:采用物理发泡方式制备了不同密度等级泡沫混凝土,研究了泡沫混凝土经高温热处理后的性能和结构演化。结果表明:随热处理温度提高,各密度泡沫混凝土的质量损失增加、抗压强度降低、吸水率增加,且均在800℃时趋于一致。密度等级对高温热处理后的泡沫混凝土性能影响较为明显。在400℃以前, 300~400kg/m3密度等级的泡沫混凝土质量和抗压强度损失更大,吸水率增加更多;在600℃温度处理后,各密度等级的泡沫混凝土基本性能均出现明显下降;在800℃时,各密度等级泡沫混凝土基本性能趋于一致,质量损失为20%左右,质量吸水率为65%~70%,基本丧失抗压强度。

Abstract:Foam concrete with different density was prepared, the properties and structural evolution of foam concrete after high temperature heat treatment were studied. The results showed that the mass loss increases, the compressive strength decreases, the water absorption increases with the increasing of heat treatment temperature and all these tend to be consistent at 800℃. The effect of different density on the performance of foam concrete after high temperature heat treatment is obvious. The mass loss and water absorption increase higher, the compressive strength decrease higher when the density of foam concrete is 300~400kg/m3 under 400℃. The basic performance of different density of foam concrete decrease obviously when the heat treatment temperature is 600℃. All these basic performance tend to be consistent at 800℃, the mass lose is 20%, water absorption is 65%~70% and the compressive strength is almost zero.

关键词:
泡沫混凝土;轻质;高温
扫二维码用手机看
未找到相应参数组,请于后台属性模板中添加
(1)轻质泡沫混凝土受高温作用后的质量损失与密度等级有关,孔隙率更大、含水率更高的低密度(300~400kg/m3)的泡沫混凝土在400℃以前质量损失较大, 500~700kg/m3的泡沫混凝土则在500~600℃温度区间失重更大;在700℃时300~700kg/m3泡沫混凝土质量损失趋于一致,在800℃时质量损失率均在20%左右。
(2)轻质泡沫混凝土在高温下的抗压强度与密度等级有关,低密度(300~400kg/m3)泡沫混凝土随着受热温度提升强度下降更为明显,在100℃出现明显下降,在700℃即已经丧失抗压能力,500~700kg/m3的泡沫混凝土随温度升高抗压强度表现规律类似,其中600~700kg/m3承受高温能力较强,在600℃高温作用后仍残存60%以上的强度,在800℃时各密度泡沫混凝土均已丧失抗压强度。
(3)轻质泡沫混凝土的吸水率与密度等级有关,在400℃以前,泡沫混凝土吸水率与质量损失有关,且随温度的增加幅度与容重等级成反比,在400~800℃吸水率大幅增加,在800℃后各容重泡沫混凝土吸水率均趋于一致。
(4)通过XRD和SEM分析可得出,200℃时泡沫混凝土内自由水逸出、钙矾石分解;400℃时C-S-H凝胶明显分解,Ca(OH)2晶体露出;600℃时Ca(OH)2晶体分解大半,基体出现CaO;800℃以上CaCO3分解,生成的CaO与水泥中残存的SiO2在高温下形成了C2S。
[1] 李军伟.泡沫混凝土的研究和应用进展[J].上海建材,2010(1):27-28.
[2] 张景飞,冯明德,陈金刚.泡沫混凝土抗爆性能的试验研究[J].混凝土,2010(10):10-12.
[3] 李应权.我国混凝土行业发展现状[J].混凝土世界,2010(12):24-28.
[4] 傅秀新,潘志华,王冬冬.泡沫混凝土用作防火型保险柜柜壁隔热填充材[J].南京工业大学学报:自然科学版,2009,31(3):106-110.
[5] 蒋冬青.泡沫混凝土应用新进展[J].中国水泥,2003(3):46-48.
[6] NORIZAL N , HANIZAM A. Lightweight foamed concrete in construction[C]. // Proc of 2005 International Conference on Construction &Real Estate Management.Beijing: China Architec ture & Building Press,2005.
[7] MDAZREEOM,WANG  Y C .Mechanical properties of foamed con-crete exposed to high temperatures[J].Construction and Building Materials,2012(26):638-654.
[8] KHOURY G A,MAJORANA C E,PESAVENTO F,et al.Mode ling of heated concrete[J].Magazine of Concrete Research,2002,54:77-101.
[9] Franziska Krauss Juillerat,Urs T Gonzenbach,Ludwig J Gauckler.Tailoring the Hierarchical Pore Structures in self-setting Particle-stabilized Foams Made from Calcium Aluminate Cement[J].Materials Letters,2012,70:152-155.
[10] 傅博,杨长辉,程臻赟.高温对碱矿渣水泥石产物及微结构的影响[J].华中科技大学学报:自然科学版,2013,41(5):34-38.
[11] 管文.影响泡沫混凝土吸水率的因素及改善措施[J].建筑砌块与砌块建筑,2011(2):45-50.
 

张雷,李军,卢忠远,.高温热处理对泡沫混凝土性能的影响[J].混凝土与水泥制品,2017(3):55-59.

ZHANG L, LI J, LU Z Y,et al.Effects of High Temperature Heat Treatment on Performance of Foam Concrete[J].China Concrete and Cement Products,2017(3):55-59.

相关文件

暂时没有内容信息显示
请先在网站后台添加数据记录。

关注《混凝土与水泥制品》

总访问量 468,401   网站统计

官方微信公众号关闭
苏州混凝土水泥制品研究院有限公司

关于我们    |    联系我们    |    订购杂志    |    回到顶部

版权所有:中国混凝土与水泥制品网  苏ICP备10086386号   网站建设:中企动力 苏州

版权所有:中国混凝土与水泥制品网

苏ICP备10086386号

网站建设:中企动力 苏州